This website uses cookies. By using the site you are agreeing to our Privacy Policy.



RAW FILE CONVERTER EX 3.0 powered by SILKYPIX (Ver.8.1.1.0) Installer for Windows

Overview

This software is made by "Ichikawa Soft Laboratory". When you install it, you need to accept "Ichikawa Soft Laboratory License Agreement".

Notes

  • Please read this update after refreshing this page.
    * In case of Windows (Internet Explorer / FireFox / Google Chrome), hold down the "Control" key and "F5" key.
  • This software can be used with models which are compatible with the old RAW FILE CONVERTER EX or RAW FILE CONVERTER EX2.0.

System Requirements

OS* Windows 10
Windows 8.1
Windows 7 (SP1)
CPU Intel Pentium® processor-based PC or compatible computer. (Core 2 Quad or later is recommended)
*Multi-core processor ready (Intel Core i7, i5, Core 2 Quad, Core 2 Duo, AMD athlon 64x2, etc.)
RAM 2GB or later is recommended
Free disk space
  • Please reserve at least 150MB of space.
  • Please allocate sufficient disk space for image storage (1 image may use more then 10MB of disk space)
    *Startup software may be used as a temporary file for up to 10GB to improve performance.
Video XGA (1024 x 768), Full Color (24 bit or higher)
Other Keyboard, mouse, or equivalent devices.
  • * Other versions of Windows are not supported. Only pre-installed operating systems are supported; operation is not guaranteed on home-built PCs or PCs that have been upgraded from earlier versions of Windows.

Detail of the update

The software update Ver.8.1.1.0 incorporates the following issue:

  1. 1. Applicable model for the "RAW FILE CONVERTER EX 3.0 powered by SILKYPIX" is added.
    Applicable Model : FUJIFILM GFX100

The software update Ver.8.1.0.0 incorporates the following issue:

  1. 1. The sign to show that the software is provided by ”Ichikawa Soft Laboratory” is displayed on the background of the RFC EX3.0.

The software update Ver.8.0.2.0 incorporates the following issues:

  1. 1. Applicable model for the "RAW FILE CONVERTER EX 3.0 powered by SILKYPIX" is added.
    Applicable Model : FUJIFILM X-T30
  2. 2. Fix of slight defects.

The software update Ver.8.0.1.0 incorporates the following issue:

  1. 1.Applicable model for the "RAW FILE CONVERTER EX 3.0 powered by SILKYPIX" is added.
    Applicable Model : FUJIFILM GFX 50R

Regarding install software

  • * If you have a inquiry, please contact your local FUJIFILM support center or through "Contact US" below.
  • * This software is made by "Ichikawa Soft Laboratory". When you install it, you need to accept "Ichikawa Soft Laboratory License Agreement".

Note

  • * The speaification of the software can be changed without notice.
  • * FUJI EXPRESSLY DISCLAIMS ANY WARRANTY FOR SOFTWARE. SOFTWARE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT OF COPYRIGHT, PATENT, TRADE SECRET, OR ANY OTHER PROPRIETARY RIGHTS OF ANY THIRD PARTY. IN NO EVENT SHALL FUJI BE LIABLE FOR ANY GENERAL, SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL, INCIDENTAL, OR OTHER DAMAGES RESULTING FROM THE USE OF OR INABILITY TO USE SOFTWARE.